One of the errors when it becomes impossible to use a PC is Please enter Setup to recover BIOS setting what to do with this problem far from everyone knows. However when it does not need to panic – the problem is solved easy enough.
The content of the article:
- 1 What is this error Please enter Setup to recover BIOS setting
- 2 What may cause Please enter Setup to recover BIOS error setting
- 3 What to do if a message appears when the computer boots Please enter Setup to recover BIOS setting
What is this error Please enter Setup to recover BIOS setting
BIOS chip
“Please enter Setup to recover BIOS setting” является скорееsystem message than error. Similarly computer tells the user that with the existing BIOS configuration The computer cannot continue to boot.
In this regard, he asks the user to load the BIOS settings. default (factory preinstalled by the motherboard boards).
What can cause Please enter Setup to recover BIOS error setting
Battery on motherboard
There are many reasons for this message. If the motherboard is old, then its appearance is probably due to a dead battery. Yes, there is a separate element on the motherboard power supply that maintains the watch and supports saving BIOS configuration.
Another option is the incorrect BIOS setup. If the user made mistakes when configuring this system, then the PC may stop loading and start displaying the message “Please enter Setup to recover BIOS setting “.
And the third option – removed or improperly placed jumpers on the motherboard. In modern motherboards, they hardly however, they are used on older ones quite a lot. Answer they, like the BIOS, are for the hardware configuration.
What to do if a message appears when the computer boots Please enter Setup to recover BIOS setting
Please enter Setup to recover BIOS setting
If a corresponding error occurs, first of all You must complete the steps that the computer offers. More often all he says: press F1 to open the settings (“to Run Setup “), press” F2 “to load the default configuration (“to load default …”). To restore your computer try clicking on F2. As a result, the computer will restart, and will start to load normally.
If the computer did not respond to pressing “F2”, then probably BIOS set Legacy in the keyboard settings, then how the user uses USB. In this case, you need to find a keyboard that connects via PS / 2 and try to execute appropriate actions from her.
However, if the computer has taken appropriate action, but after he was unplugged, please enter error Setup to recover BIOS setting again appeared, then rather of all, the battery is dead. This battery can be bought at almost any electronics store. You’ll need to purchase a battery, open the system unit case and put the old one in its place new one.
Jumpers on the motherboard
If jumpers are incorrectly placed, which, however, it is unlikely that you need to find the circuit of the corresponding switches for your model board and set jumpers in the correct okay.
